普洱附近想过夜电话联系

Welcome to Yongsheng Machinery. We provide you with mixing machine, feeding machine, automatic mixing line, PET film cleaning line and PE film cleaning line  Scan, the content is more wonderful

National service hotline

thirteen billion seven hundred and seventy-three million two hundred and twenty-one thousand one hundred and sixty-eight
 Immortal machinery
 Immortal machinery

Adjustment of feeding rate of feeder

Release date: 2020-05-28 16:55

Feeding machine is one of the indispensable production equipment in stone production. We know that only by serious work can we give better. So what kind of operation is used to adjust the feed volume?
1. Adjust the amplitude of the feeder. Within the range of the rated amplitude, the amplitude can be directly adjusted by turning the potentiometer knob or inputting the automatic control signal, so that the feeding amount of the feeder can be adjusted steplessly.
2. Adjust the opening of the bin gate, change the thickness of the material layer, and also adjust the feed rate.
3. When the feeding accuracy is guaranteed, the faster the feeding speed of single feeding machine is, the better. However, in the automatic batching line with multiple feeders, the discharging speed of these feeders should be matched with each other to make all kinds of raw materials evenly mixed.
 charging machine
4. Generally, no-load test run for no less than 4 hours has been carried out before the feeder leaves the factory. After the installation and adjustment, a short-term test run should be carried out. During the test run, the amplitude and current should be stable.
5. The feeding capacity of the feeder is directly proportional to the amplitude, so increasing the amplitude can improve the feeding capacity, but this will damage the particles of the material, so the amplitude is generally controlled within 0.5-1.5 mm.
six charging machine In the process of operation, the amplitude of feeding trough and coil current must be checked frequently. If the plate spring bolts are loose or the plate spring is broken, the air gap between iron core and armature changes or collides, it should be handled immediately.
7. When the feeder is just running, the inspection times should be increased appropriately. Pay special attention to the sound of the feeding machine. If the sound suddenly becomes loud, carefully analyze the cause. The seal cover of the vibrator must be covered to prevent the gap between the plate springs from being blocked.